Just making a quick post here to ask your opinion on something.
The SAVA 10 and 15 systems have a small circuit board in the RH speaker.
Now developing the retrofit kits for these systems I can build it two ways.
So I figured I would ask you guys how you would want them built.Option A: Is to provide two plugs that will hook to the existing speaker wires in the RH speaker. Therefore making the little circuit board pictured above obsolete. (Note SAVA 10 owners will have to replace the 2 pin connector also on their systems because of the style of connector that sony used. Basically its soldered to the board, so you can’t unplug it. This will require crimping a new connector in to place, or I can make up a pig tail. ) Option B: Is to unsolder the the large black connector on the small circuit board shown above and I will provide you with a new one in the kit to fit the new cable. I will be able to build this cable cheaper than Option A just because its less parts and less labor.
As I mentioned in the comments below, both solutions will require soldering, because you have to replace the factory connector on the amp in the LH speaker. (unless some one has an injection molding machine) A new replacement connector for the LH side will be included in the kit, along with a manual that shows how to install this kit into your stereo.
Thoughts, Questions, Concerns Post them in the Comments below.