Just making a quick post here to ask your opinion on something.
The SAVA 10 and 15 systems have a small circuit board in the RH speaker.
Now developing the retrofit kits for these systems I can build it two ways.
So I figured I would ask you guys how you would want them built.
Option A: Is to provide two plugs that will hook to the existing speaker wires in the RH speaker. Therefore making the little circuit board pictured above obsolete.
(Note SAVA 10 owners will have to replace the 2 pin connector also on their systems because of the style of connector that sony used. Basically its soldered to the board, so you can’t unplug it. This will require crimping a new connector in to place, or I can make up a pig tail. )
Option B: Is to unsolder the the large black connector on the small circuit board shown above and I will provide you with a new one in the kit to fit the new cable.
I will be able to build this cable cheaper than Option A just because its less parts and less labor.
As I mentioned in the comments below, both solutions will require soldering, because you have to replace the factory connector on the amp in the LH speaker. (unless some one has an injection molding machine) A new replacement connector for the LH side will be included in the kit, along with a manual that shows how to install this kit into your stereo.
Thoughts, Questions, Concerns Post them in the Comments below.
Wow, its been a while since I have updated this blog but I am bringing good news today.
Long story short I have found a connector that will work for the SA-VA 10 and 15 units.
It’s not a direct plug and play like the rest of my cables, you will have to remove the old connector on the LH side
and solder the new connector in place. The RH side did yield itself to be a little more user-friendly and is a plug-in connection to the internal speaker connectors.
I have a SA-VA 15 unit in-house to develop this kit on, so its ready to go. But Sony changed the wiring and connectors on the SA-VA 10 units, and this has provided me with a little snag. Therefore, if you own a SA-VA 10 unit and have a screwdriver and a digital camera please contact me.
I know many of you have been waiting for me to find these connectors.
Well, there is good new and bad news. I have found them, the problem is they have been discontinued (According to the West coast office). If you call the East coast office they tell you the tooling has been destroyed and give you some big run around. I have been dealing with these clowns for over four months trying to get the correct parts quoted.
So here is all the information I have obtained.
FG Connector for SAVA 10, 15, 35, 100
Part number: SAVA 10 — > CFG1313-0101 13 Pin Connector
SAVA 15 –> CFG1313-0101 13 Pin Connector
SAVA 35– > CFG1315-0101 15 Pin Connector ****
SAVA 100 –> CFG1315-0101 15 Pin Connector ****
****Need to verify pin count on connectors.
Marketing Assistant / Distributor Account Specialist SMK Electronics Corp U.S.A.
1055 Tierra Del Rey, Suite – H
Chula Vista CA. 91910
Ph: (619) 216-6479
Fax: (619) 216-6499
Here is the link to SMK USA